subject: Kyocera Mita FS-4000DN Review [print this page] Kyocera Mita FS-4000DN Review Kyocera Mita FS-4000DN Review
The single issue you really pay money for in laser printers will be speed. If you want a swift printer, suitable to share over a workgroup, there's a significant cost premium. The FS-4000DN from Kyocera Mita is graded at 45ppm (pages per minute) and will cost you approximately 600.
The look is typical enough; a simple cube with a sloping user interface at the front end. Including a backlit, 2-line by 16-character display screen as well as a selection of eight buttons, this includes a couple of substantial ones to commence and cease a print run. It may seem peculiar to include a start button for what is sold as a workgroup laser, however it is to handle prints of PDF files, which may be created from a memory drive connected directly into the printer. This can be a helpful extra and delivers protection for files you don't want to leave in the output tray.
A complete ream of paper can be entered in to the FS-4000DN's primary paper tray and there is a fold-down multi-purpose tray, also, which can take as much as 100 sheets of special media. If you'd like more than this, Kyocera Mita can easily offer three further input trays, a face-up output tray plus a cabinet to help support the printer, all as options.
What of the print rate? Printer designers usually rate their equipment by printing very simple documents in draft mode, therefore headline statistics need to be taken with a small pinch of salt. The best single-sided print rate we were treated to in normal mode ended up being only just over 14ppm, just one third of the described top rate. Using the built-in duplexer engaged we produced a two-sided document at 23 sides per minute, closer to the stated speed of 33.5spm.
Speed is only fifty percent of the equation, needless to say; the other half is print quality. This isn't as good as we've experienced in the past from Kyocera Mita printers. Whilst it is okay for text print, that is jet black and exact, the same can not be said for photographs, or even business graphics. In each cases a series of fine micro-bands are obvious across the prints, that might cause problems, even for internal office use.
Print costs are small, because of the permanent drum design present with all Kyocera Mita lasers. All you have to buy is toner - a 20,000-page Kyocera Mita FS-4000DN toner cartridge. It's straightforward to fit, too, so upkeep is simple.
This is a sound workgroup printer, swift to print - although somewhere short of Kyocera Mita's claims - and simple to expand. Working expenses are low and it really is solely in the area of print quality that we have any worries.
Kyocera Mita FS-4000DN toner cartridges are available here.
welcome to Insurances.net (https://www.insurances.net)
